The Transmitter reads the SDI ANC data for camera control and Tally.
Reads the Data for the selected camera ID and converts this SDI Control Data to our wireless CCU Camera Protocol.
Connect this output to the SDI IN from the camera and it will be controlled wireless from the Atem.
On the Transmitter you can configure the Camera ID to listen to and Wireless communication channel for the WRCU.
Transmitter has a SDI Loop output to send data to the next unit or monitor.
Ethernet and Hirose connector are for future functionality.
Unit is powered trough the USB-C port which also is for future FW upgrades.
Vlock Receiver will pass power from Battery to the camera.
USB-C is for future FW upgrades.
Ethernet and Hirose connector are for future functionality.
3,5mm jack is an External tally output and is designed for use with the Datavideo TD-3 Tally light. (Not supplied but can be ordered as optional )
RX Vlock Camera unit:
SDI Control output for CCU and Tally
Vlock Pass Power
Oled for menu settings
Tally by internal LED and External 3,5mm output for tally light + embedded into SDI for in camera Tally.
TX Transmitter unit:
SDI Input from Atem
SDI Loop output
Powered from 5V USB-C
Oled for menu settings
Tally indicator
Wireless Specification:
Frequency Set: Worldwide 2.4GHz ISM band operation
Frequency: Selectable 2.400GHz to 2.525GHz
Channel Spacing: 1Mhz steps, 125 Channels.
Bandwidth: 1Mhz Bandwidth required
Range: 150 meter (500ft) depending on environment and RF interference!
Already tested and confirmed:
Ursa Broadcast 4K G1 / G2
Ursa Mini Pro models
Micro Studio Camera 4K
Bewertungen
Es gibt noch keine Bewertungen.